Account
Ecigone BlogsWhy Is My Vape Leaking?

Why Is My Vape Leaking?

Why is my vape leaking: from the bottom, from the air hole or into your mouth

A vape leaks for one of four reasons nearly every time: the coil has flooded, the pod or tank was overfilled, the e-liquid is too thin for the coil, or a pod, coil or seal is not seated or has worn out. All four take a few minutes to fix and none of them means the kit is broken.

The quickest way to find yours is to look at where the liquid is coming from. This guide starts with the fix that clears most leaks, then goes through each place a vape leaks from, for refillable pods, tanks and prefilled kits.

How to fix a leaking vape

These five steps clear most leaks on any refillable kit. Work through them in order.

  1. Take the pod or tank off and dry everything. Wipe the base of the pod, the contacts and the inside of the kit with a tissue. Liquid left on the contacts is what makes a kit misfire.
  2. Clear the flooded coil. Hold the pod over a tissue, mouthpiece down, and flick it gently. Then blow softly through the mouthpiece to push spare liquid out of the airway.
  3. Check the pod, coil and seals. Look for hairline cracks, a coil that is not pushed fully home and seals that are torn, flattened or missing. Replace anything damaged.
  4. Refill below the top. Leave a small air gap, keep liquid out of the centre airway and close the fill port firmly.
  5. Refit it and take a few short puffs. Seat the pod straight and firmly, stand the kit upright and take three or four short, gentle puffs to settle the coil.
How to fix a leaking vape in five steps: dry it, clear the flood, check it, refill below the top, refit and puff

If it still leaks after that, the pod or coil is at the end of its life. A fresh one from our coils and pods range nearly always ends it.

Where is your vape leaking from?

The place the liquid appears tells you the cause.

Where is your vape leaking from: the bottom, the air hole or into your mouth, with the likely cause and fix for each

Vape leaking from the bottom

Liquid under the pod or around the base means it has come down through the coil or past a seal. The usual causes are overfilling, a pod that is not seated, a coil that is not pushed fully in, or a cracked pod. Condensation also collects here, which is covered further down.

Dry the base and the contacts, check the pod for cracks and refit it firmly. On a tank, unscrew the base and make sure the coil is tight and its seals are in place.

Vape leaking from the air hole

Liquid at the airflow holes means the coil has flooded. There is more liquid in the coil than it can turn into vapour, so the extra finds the easiest way out. It happens after overfilling, drawing hard, taking puffs without the kit firing, or leaving the kit on its side.

Clear the flood with step two above, then keep the kit upright. If you have adjustable power, a setting that is too low for the coil floods it as well, so move up to the range printed on the coil.

Vape leaking into your mouth

Liquid in your mouth is a flooded coil again, or liquid that has gone down the centre airway while filling. A hard, fast draw pulls liquid up before the coil can vaporise it.

Draw slower and more gently, clear the flood, and fill down the side of the pod or tank, never the centre tube.

Why is my vape spitting?

Spitting is small drops of hot liquid popping off a wet coil. The cause is the same as a leak into the mouth: too much liquid on the coil. It is most common with a new coil, thin e-liquid, or a low power setting.

  • Flick the spare liquid out and take a few short puffs before a full draw.
  • Raise the power a little if your kit lets you, staying inside the coil's range.
  • Use a thicker e-liquid if the coil is a low resistance one.

A light crackle on its own is normal. Our guide to why a vape crackles covers the sounds that are fine and the ones that are not.

Why is my new pod leaking?

A brand new pod that leaks has nearly always been used too soon or filled too full. The cotton in a new coil needs time to soak, and until it has, liquid sits in the airway.

  • Fill below the top and close the port firmly.
  • Leave it to stand for five minutes before the first puff.
  • Seat the pod fully, then start with short, gentle puffs.

Our guide on how to prime a coil shows the steps. A new pod that leaks while closed, seated and standing upright is faulty and should be replaced.

Is it a leak or condensation?

Not every drop is a leak. Vapour cools on its way out and turns back into liquid, and that collects under the pod and inside the mouthpiece on every kit. A thin film or a few small drops on the contacts after a day of vaping is condensation.

How to tell a vape leak from condensation

The test is simple. Wipe it dry and check the liquid level. If the drops come back slowly and the level has barely moved, it is condensation, and a wipe every day or two deals with it. If the liquid level drops while the kit is not in use, it is a leak.

Why do prefilled vapes leak?

A prefilled pod is sealed at the factory, so overfilling and the wrong liquid are ruled out. What is left is condensation, a pod that is not clicked fully in, heat, and the occasional faulty pod.

  • Remove any seal or sticker from the pod before fitting it.
  • Push the pod in until it clicks, and wipe the contacts if they are wet.
  • Keep it out of hot cars and off radiators.

A prefilled pod that leaks from new is one to send back, not one to fix. Our warranty FAQs explain how to do that.

Why is my vape tank leaking?

A tank has more joins than a pod, so there are more places for liquid to escape. Check these in order.

  • The coil. Screw it in until it is snug, or push it fully home on a push-fit tank.
  • The seals. Every join has an o-ring. One that is torn, twisted or missing lets liquid past.
  • The glass. A chip or hairline crack will weep liquid.
  • The top cap. Close it fully after filling, and close the airflow while you fill a bottom-airflow tank.

The right e-liquid for your coil

Thin liquid in a coil made for thick liquid is one of the most common causes of a leak. PG is thin and VG is thick, so the ratio on the bottle matters.

The right e-liquid ratio for your coil: 50/50 for mouth to lung pods, 60/40 to 70/30 for mid coils, 70/30 or thicker for sub-ohm tanks

Your coil or kit

E-liquid to use

Mouth to lung pods, 0.8 ohm and above

50/50 nic salt or freebase

Pods and coils around 0.4 to 0.6 ohm

60/40 to 70/30

Sub-ohm tanks, 0.3 ohm and below

70/30 or thicker

A 50/50 liquid in a sub-ohm tank will flood it, and a 70/30 liquid in a small pod will struggle to soak in and taste burnt. If you are not sure which you have, our guide to choosing the right e-liquid matches liquid to kit.

Vape leaking in the heat or on a flight

Heat thins e-liquid and a change in air pressure pushes it out, so a kit that never leaks at home can leak in a hot car or a plane cabin.

  • Do not leave a kit in direct sun or a parked car.
  • Before a flight, empty the pod or tank, or leave it no more than half full.
  • Carry the pod separately from the kit, wrapped in a tissue, and keep both in your hand luggage.

How to stop your vape leaking for good

  • Fill below the top, every time.
  • Close the fill port and seat the pod firmly.
  • Stand the kit upright when you are not using it.
  • Draw gently and let the coil keep up.
  • Match the e-liquid to the coil.
  • Change the pod or coil when the flavour dulls.

When a leaking vape is faulty

If a kit still leaks with a new pod or coil, the right liquid and the pod seated firmly, the fault is in the kit or the pod. Stop using a kit if liquid has got inside the body and it misfires, will not charge or gets hot. Get in touch with your order number and we will put it right.

Leak guides for your kit

Some kits have their own habits. If you have a Vaporesso, our guide to a leaking Vaporesso pod goes through every XROS and Luxe kit one by one.

Geekvape Wenax owners have their own Wenax leak guide.

Frequently Asked Questions

Usually because the coil has flooded, the pod or tank was overfilled, the e-liquid is too thin for the coil, or a pod, coil or seal is not seated or has worn out. Dry the kit, clear the spare liquid from the coil, refill below the top and refit the pod firmly.

Liquid at the bottom has come down through the coil or past a seal. The usual causes are overfilling, a pod that is not seated, a loose coil or a cracked pod. Dry the base and contacts, check for cracks and refit it firmly. A few small drops can also be condensation.

Spitting is hot liquid popping off a coil that has too much liquid on it. It is most common with a new coil, thin e-liquid or a low power setting. Flick the spare liquid out, take a few short puffs before a full draw and raise the power a little if your kit allows.

Fill below the top, close the fill port and seat the pod firmly, stand the kit upright when you are not using it, draw gently, use an e-liquid that matches your coil and change the pod or coil when the flavour dulls. Those six habits stop most leaks before they start.

A small leak is a nuisance, not a danger. Wipe e-liquid off your skin and wash your hands, and dry the contacts before using the kit again. Stop using a kit if liquid has got inside the body and it misfires, will not charge or gets hot.

Liquid keeps soaking into the coil while the kit sits, and it escapes if the kit is on its side, somewhere warm, overfilled or holding e-liquid that is too thin for the coil. Stand it upright, keep it out of the heat and match the liquid to the coil.

Tags:How ToPods

Related Articles

The parts of a vape and the cleaning tools needed
How To
.by : shane margereson

How to Clean a Vape: Pods, Tanks, Coils and Mouthpieces

How to clean a vape properly: pods, tanks, coils and mouthpieces, what must never get wet, and the five-minute weekly routine that makes a kit last.

Image comparing Uwell G3 series pod kits and G Pod platform with various pod models and devices shown
Guides
.by : shane margereson

Which Caliburn Pod Fits Your Kit? The G Pod Platform Explained

Caliburn G3, G4 and G5 pods explained. The G Pod Platform (GPP) and GPP ALPHA are now the pods that fit the current Caliburn kits, plus which resistance to pick.

E-liquid storage guide showing bottles neatly organised in a compartment box inside a cool dark drawer to preserve flavour and freshness.
E-Liquid
.by : shane margereson

How to Store E-Liquid

How to store e-liquid so it keeps its flavour: the right temperature, why light matters, shelf life and the signs a bottle has gone bad.