Pyne Pod Click S 30K Prefilled Pod Kit

Pyne Pod Click S 30K Pod Kit

The Pyne Pod Click S 30K is a prefilled twist pod kit with approximately 30,000 puffs per kit on Regular Mode. A 900mAh battery, mesh coils, and an LED screen with puff counter all sit inside a pocket-sized MTL vape. Twist the mouthpiece to swap between two flavours without pulling anything apart.

Each Pyne Pod Click S 30K comes with two 1ml prefilled pods and two 8ml auto-refill containers holding 18ml of 20mg nic salt e-liquid total. There are 15 flavour editions to pick from, each with two Pyne Pod flavours in one kit. When the pods are empty, grab a fresh set of Pyne Pod Click S 30K refill pods and you're back vaping in seconds.

Key Features

• 30,000 Puffs approximately per kit on Regular Mode
• 900mAh Battery full day MTL use, full charge under 30 minutes
• Twist-to-Switch turn the mouthpiece to swap flavours instantly
• Dual Power Modes Regular at 10W, Boost at 20W
• Mesh Coils fitted in every prefilled pod
• LED Display battery level, puff count, and power mode
• Cross-Compatible works with Pyne Pod Click 10K, 30K, and 50K pods
• TPD Compliant UK legal post-June 2025

Pyne Pod Click Twist Dual Flavour Setup

The Pyne Pod Click S 30K twist kit holds two flavours at once. You don't remove pods to switch between them. Turn the mouthpiece one way for flavour one, twist it the other way for flavour two.

On the Pyne Pod Click 50K you physically pull pods out and swap them over. The 30K skips that step entirely. Both flavours stay loaded and you rotate between them with a quarter turn of the mouthpiece. Handy if you like alternating between a fruit and a menthol throughout the day.

Regular Mode and Boost Mode

Two power settings on the Pyne Pod Click S 30K, switched by double clicking the button on the front of the kit.

Regular Mode stays cooler and stretches the 18ml of e-liquid further. Boost Mode doubles the wattage for a warmer, fuller draw but burns through liquid and battery faster. The LED screen shows which mode is active so you always know where you're set.

900mAh Battery and USB-C Charging

The Pyne Pod Click S 30K uses a 900mAh battery. That's bigger than the Pyne Pod Click 50K and lasts a full day for most MTL vapers. USB-C charging gets you from flat to full in under 30 minutes (cable not included in the box).

Regular Mode pulls less power per puff so the battery lasts longer between charges. On Boost Mode at 20W expect to charge once or twice during the day depending on how heavily you vape.

Mesh Coils and MTL Draw

Every Pyne Pod Click S 30K pod has a mesh coil already fitted inside. Mesh heats the e-liquid more evenly than a standard round wire coil so the flavour holds up from the first draw right through to the end of the pod. No coil swaps, no priming, no maintenance at all.

The draw is mouth-to-lung with inhale activation. Pull on the mouthpiece and the kit fires on its own. The 20mg nic salt e-liquid pairs well with the tight MTL airflow and gives a smooth throat hit at both wattage settings.

Pyne Pod Click Cross-Compatibility

The Pyne Pod Click S 30K accepts pods from across the Pyne Pod Click range. Pyne Pod Click 10K, 30K, and 50K replacement pods all fit this kit. If you already own a Pyne Pod Click 50K, the 30K twist pods work in that kit too.

That cross-compatibility means more flavour options across the full Pyne Pod lineup without buying a separate kit for each pod type.

Pyne Pod Click S 30K Specifications

Pyne Pod Click S 30K Flavours

Fifteen flavour editions, each with two Pyne Pod flavours in one kit.

All editions use 20mg nic salt e-liquid.

How to Set Up the Pyne Pod Click S 30K

1. Charge the kit fully using a USB-C cable (not included in the box)
2. Remove all rubber plugs and stickers from the pod and refill containers
3. Click the two 8ml refill containers into the base of the pod unit until they snap in
4. Slide the assembled pod unit into the battery base and press down firmly
5. Remove the mouthpiece plug
6. Inhale to start vaping

Switching flavours: Turn the mouthpiece. One way for flavour one, the other way for flavour two.

Switching power modes: Double click the button. The LED screen shows R for Regular or B for Boost.

What's in the Box?

• 1x Pyne Pod Click S 30K Kit (900mAh battery)
• 2x 1ml Prefilled Pyne Pod Click Pods (mesh coils fitted)
• 2x 8ml Auto-Refill Containers
• 1x User Manual
• USB-C charging cable not included