OXVA NeXlim Go Pod Vape Kit

OXVA NeXlim Go

The OXVA NeXlim Go is the screen-free kit in OXVA's NeXlim range: a 40W dual mesh pod with an 1800mAh battery that OXVA rate at up to 10 days in Eco mode. A slide switch on the side changes between Boost and Eco, and the kit fires as soon as you draw, so there is nothing to scroll through before you vape. It sits with the rest of the OXVA vapes we sell.

It takes the same NeXlim cartridges as the original NeXlim, with two mesh coils in each one. Boost heats both meshes together for more flavour and Eco takes them in turns so each cartridge lasts longer, and with three resistances to pick from, OXVA count six ways to vape it, from a tight mouth to lung draw to a looser restricted direct lung draw.

OXVA NeXlim Go Features

• 5 to 40W with Boost and Eco modes on a slide switch
• Dual mesh UniTech 2.0 cartridges
• 1800mAh battery, up to 10 days in Eco mode
• 5V/2A USB-C charging, full in about 45 minutes
• Auto draw that fires in 0.01 seconds
• Tri-colour battery light and no screen
• Side airflow control from MTL to RDL
• Fits every NeXlim cartridge, in 8 colours

Boost and Eco Modes

Slide the switch to Boost and both mesh strips heat at once, which OXVA say widens the heating area for a fuller flavour. Slide it back to Eco and the two meshes take turns, which stretches the life of each cartridge and of the battery. The screen-free design means the switch position is the only setting to check.

1800mAh Battery

The 1800mAh battery charges by USB-C at 5V/2A, and OXVA say it goes from flat to full in about 45 minutes. They rate it at up to 10 days of use in Eco mode, though how long yours lasts depends on how much you vape and which cartridge you use. The light on the front shows the charge: green above 65%, yellow from 30% to 65% and red below 30%.

How to Use the OXVA NeXlim Go

To use the OXVA NeXlim Go, fill the cartridge, give the coil a few minutes to soak, then draw to vape. The instructions come down to six steps:

1. Fill the cartridge with freebase or nic salt e-liquid, then close it straight away to help stop leaks.
2. Leave it for a few minutes so the coil soaks through before the first puff.
3. Push the cartridge into the kit.
4. Pick Boost or Eco with the slide switch.
5. Set the airflow on the side, tighter for MTL or more open for RDL.
6. Draw to vape.

The light on the front tells you how much charge is left:

Light	What it means
Green	Battery at 65% to 100%
Yellow	Battery at 30% to 65%
Red	Battery under 30%, charge it soon

OXVA NeXlim Go Not Working

If the OXVA NeXlim Go is not working, start with the battery and the cartridge:

1. Charge it. A red light means the battery is under 30%, and a flat battery will not fire.
2. Take the cartridge out, check the contacts on the cartridge and in the kit are clean and dry, then push it back in firmly.
3. Check the cartridge has e-liquid in it and has had time to soak.
4. If it still will not fire, fit a fresh cartridge.

NeXlim Go Pods

The NeXlim Go takes NeXlim cartridges in 0.6, 0.8 and 1.2 ohm, from a looser RDL draw on the 0.6 ohm to a tight MTL draw on the 1.2 ohm, and the UK kit comes with the 0.8 ohm. OXVA also make an empty NeXlim cartridge that takes NeXlim replacement coils.

Spare NeXlim Go pods come in packs of three, and the same cartridges fit the NeXlim, NeXlim 2 and NeXlim 2 Mini.

OXVA list both freebase and nic salt liquid for the NeXlim Go.

How Long Do NeXlim Go Pods Last

OXVA rate each NeXlim Go cartridge at up to 30 refills in Eco mode. Boost heats both meshes at once, so expect fewer refills when you vape in Boost. A cartridge is due for a change when the flavour fades or tastes burnt, and with the empty cartridge you can change just the coil.

If you own more than one OXVA kit, our OXVA pods page has every NeXlim, Xlim and VPrime cartridge together.

NeXlim Go vs NeXlim

The NeXlim Go and the original OXVA NeXlim share the same dual mesh cartridges and 40W top output. These are the differences in OXVA's figures:

	NeXlim Go	NeXlim
Battery	1800mAh	1500mAh
Screen	None, tri-colour battery light	0.85 inch colour screen
Boost and Eco	Slide switch	Button presses
Output	Up to 40W	Up to 40W
Charging	5V/2A	5V/2A
Pods	NeXlim cartridges	NeXlim cartridges
Colours	8	18

For a bigger 2000mAh battery and the leak-resistant UNITECH 3.0 cartridge, the OXVA NeXlim 2 is the follow-up model.

OXVA NeXlim Go Colours

The OXVA NeXlim Go comes in 8 colours, from brushed metallic finishes to smooth silky ones:

• Black Warrior
• Rose Pink
• Sahara Brown
• Silky Black
• Silky Coffee
• Silky Purple
• Space Grey
• Starry Blue

OXVA NeXlim Go Specifications

These are OXVA's specifications for the NeXlim Go, a rechargeable vape with a built-in battery you charge by USB-C.

Specification	Details
Output	5 to 40W
Modes	Boost and Eco, slide switch
Firing	Auto draw
Battery	1800mAh built in
Charging	USB-C, 5V/2A, full in about 45 minutes
Battery light	Tri-colour indicator
Coils	Dual mesh, UniTech 2.0
Pods	NeXlim cartridges, 0.6, 0.8 and 1.2 ohm
Resistance range	0.2 to 3.0 ohm
Airflow	Side adjustable
E-liquid	Nic salt and freebase
Material	PC, PCTG and PC/PU

What's in the Box

The UK kit comes with:

• 1 x OXVA NeXlim Go device
• 1 x NeXlim 0.8 ohm cartridge
• 1 x User manual

OXVA do not list a USB-C cable in the box, so use the one from your phone or another kit.

For more on NeXlim cartridges and how the range compares, read our guide to the OXVA NeXlim.